Which is better a rc electric plane or a rc gas plane and whats a good plane to get after a trainer?
Posted by admin
I like electric but I like gas and I have a Slow Stick and a S-Ray what should I get now?
we recently broke our fuselage so i would recaomend buying the cheapest plane if u are a beginner in the arty of flying areoplanes
good and bad points of plastic and foam rc airplanes?
Posted by admin
What are the good and bad points about Plastic rc airplanes and those foam epp airplanes? Which one would you suggest for a beginner?
EPP aircraft are just about unmreakable. Other foams, (expanded polyurethane being one), break quite easily but are quickly repaired with the right cyano. All plastic ‘plabes are ARTF so building is reduced to the minimum.
Is this a good RADIO CONTROL AIRPLANE for a beginner ???????????? Do you recommend this ???????????~~~~~THANKS
Posted by admin
i found this RC airplane on ebay and i think it’s pretty good but it’s my first airplane and im not sure if this is the right one for me…it will cost me $70 for me to buy this ! what do you think ??? should i buy this ?
http://cgi.ebay.ca/Radio-Control-Electric-2-Ch-Learjet-35-Airplane-RTF-RC_W0QQitemZ280226832598QQihZ018QQcategoryZ2563QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
thanks a lot !!!
or how about this ?
http://cgi.ebay.ca/Radio-Control-Electric-2-Ch-Learjet-35-Airplane-RTF-RC_W0QQitemZ280226832598QQihZ018QQcategoryZ2563QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
this would be a great rc plane (which was my first)
its lesser than $70
i think its about $39
try searhing for the supersonic rc trainer plane
How do I clean model fuel from balsa wood on my RC aircraft?
Posted by admin
I am rcovering my model with Monokote and when I stripped off the old covering I noticed that nesr the nose of the plane some fuel has penetrated into the wood. I would like to know how to clean it or use soething to draw it out of the wood.
Thanks,
As far as I know there is no way to remove the nitro from the balsa ,,
what you may have to do is cut the piece out and replace it with new if it is an area that will be getting mono cote ,
what I would do is saturate the area with super thin CA and see if you can make the area solid for application of the mono cote.
I need help on picking a new radio controlled plane :)?
Posted by admin
Hello,
I have broken so many RC planes. that’s because they are over rated. I have had one great one though called the firebird outlaw by hobby-zone. basically i want a beginner plane, that flys nice, stable and quite slow. Any recommendations? thanks!
Try going for the Air Hogs product line. Their products are made of mainly foam and the planes are very durable. They have a 2 channel function, so there isn’t much controls to worry about. Just the up/down, left right basic controls. They are very stable and slow. These planes are made for people of all ages, except for I think ages 8 and under.
